Forum Thread: PSI shows no information

You are currently viewing a forum thread in the Secunia Community Forum. Please note that opinions expressed here are not of Secunia but solely reflect those of the user who wrote it.

This thread was submitted in the following forum:
PSI

This thread has been marked as locked.
iagomanx PSI shows no information
Member 24th Nov, 2013 21:17
Ranking: 0
Posts: 1
User Since: 17th Nov, 2013
System Score: N/A
Location: N/A
I d/l the latest version and ran it. No data shows and it states I am 85% worst in USA
It used to work so nicely until I had to re-install it when I had to re-install Win/XP pro.
I even looked at my backups from before my re-install to see if there was a different version running.
There wasn't. It's been V1.5.00 always.

mogs RE: PSI shows no information
Expert Contributor 24th Nov, 2013 22:00
Score: 2265
Posts: 6,269
User Since: 22nd Apr 2009
System Score: 100%
Location: UK
@iagomanx

Best thing is to check all your settings are in order...as per the FAQ here :-
The Secunia PSI won’t load the interface or won’t complete scanning. What can I do?
http://secunia.com/vulnerability_scanning/personal... note the last paragraph which pertains to XP users in particular.
Some users have still had problems with the latest psi version.....you could try a re-install of psi 3.0....if that doesn't work I'd go for the psi 2.0 version to be found here :-
http://secunia.com/products/consumer/PSI/sys_req/ ( See the right of the page ). In either or both cases, let it remove the previous version.

Hope it helps.......regards.......mogs......

--
Was this reply relevant?
+0
-0

This thread has been marked as locked.