Secunia
Login
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Forum Thread: Switching from Simple to Advanced interface mode
You are currently viewing a forum thread in the Secunia Community Forum. Please note that opinions expressed here are not of Secunia but solely reflect those of the user who wrote it.This thread was submitted in the following forum:
PSI
| ronhovde | Switching from Simple to Advanced interface mode |
|---|---|
 |
12th Mar, 2010 16:30 |
|
Ranking: 0 Posts: 1 User Since: 27th Mar, 2009 System Score: N/A Location: N/A |
If I switch from simple to advanced interface mode but then find that the advanced mode is too advanced for me, can I switch back to the simple mode? |
| Anthony Wells | RE: Switching from Simple to Advanced interface mode | ||||||||
|
12th Mar, 2010 16:38 | ||||||||
| Score: 2324 Posts: 3,203 User Since: 19th Dec 2007 System Score: N/A Location: N/A Last edited on 12th Mar, 2010 16:44 |
Hello ronhovde , Just click the "simple" link at the top right of any PSI page . You can come back to "advanced" by clicking on that link , ust next to it . Resetting may take a moment or two . It would be a shame not to try the "advanced" mode ; so here are some tips for "looking around" :- Click on each/all the tabs and there is plenty of written advice about what each tab contains . If a "problem" shows in the "insecure" or "end of life" tabs , then to help resolve any problem , here are some instructions to help you first of all get the best out of PSI :- 1)use PSI in "advanced" mode ; 2)in the "settings" tab make sure that the box in the first/upper section is NOT ticked in order to have the maximum info available ; 3)tell us in which "tab(s)" your problem programme is located ; 4)in that tab , click on the + in the box at the left end of the programme , the page will expand ; 5)in the expanded page , tell us what is written in the "installation path" ; 6)in the "toolbox" section , lower down , the link "technical details" should confirm the installation path details ; 7)click on the link "open folder" and you will see more details concerning the location of the "problem" . Posting these details will help the Forum help you , if/when you have a problem . Take care Anthony -- It always seems impossible until its done. Nelson Mandela |
||||||||
|
|||||||||
| This user no longer exists | RE: Switching from Simple to Advanced interface mode | ||||||||
|
|
12th Mar, 2010 20:13 | ||||||||
| Stick with Advanced mode ronhovde It takes a while to get used to it but it shows a lot of information. If you go back to Simple it enables the Easy-to-Patch feature that limits the scan results. |
|||||||||
|
|||||||||
