|kalyanakumar1985||PSI is not Detecting Adobe Shockwave player 10.x EOF updation|
|10th Sep, 2010 16:25|
User Since: 10th Sep, 2010
System Score: N/A
I have updated Adobe Shockwave player 10.x EOF to shock wave player 11.But psi is saying "you are vulnerable"
Vulnerable file is SwOnce.dll in sytem32/macromed folder
But shockwave 11 is getting installed in system32/adobe/shockwave11
Why PSI is not detecting this kind of folder changes?
I am using PSI 22.214.171.124.I hope it will get correct in next version
|Anthony Wells||RE: PSI is not Detecting Adobe Shockwave player 10.x EOF updation|
|10th Sep, 2010 17:16|
User Since: 19th Dec 2007
System Score: N/A
Last edited on 10th Sep, 2010 17:19
|Hello kalyanakumar1985 .
My up to date Shockwave 11 is only showing in the ..\System32\Adobe\... folder in the Director and Shockwave sub-folders .
I only have the Flash Folder in my ..\Ststem32\Macromed\.. folder and no Sw files .
At this stage I would navigate to the insecure file and rename it by adding _old to the end of the file , creating ..\SwOnce.dll_old .
Run a full scan (reboot if possoible) and this should stop it being detected by the PSI and the bad guys . If Shockwave behaves normally after this you could think about deleting the file .
Perhaps someone with technical knowledge will explain why the file is where it is ; maybe it was the location for Sw 10 . At one stage Sw10 was needed to play games and was compatible with 11 and Secunia had set their detection rules to allow for it ; if a programme still needs Sw10 to work , normally it will call for it to be installed .
Is your version in the "insecure" or "end of life" category ??
Hope this helps , if not ask again .
It always seems impossible until its done.
Not a customer already?