Forum Thread: No option to chose drive letters :- |

You are currently viewing a forum thread in the Secunia Community Forum. Please note that opinions expressed here are not of Secunia but solely reflect those of the user who wrote it.

This thread was submitted in the following forum:
PSI 2.0 Beta

This thread has been marked as resolved.
Marcellina No option to chose drive letters :- |
Member 30th Nov, 2010 18:21
Ranking: 0
Posts: 1
User Since: 26th May, 2009
System Score: N/A
Location: N/A
Hello,

I have updated my PSI to version 2.0 beta. Everything went fine so far. But I noticed, that my husby's installation offeres in the settings section the option to select drive letters of the partitions that should be scanned. Unfortunately on my system no drive letters are displayed.

Any idea to solve this is appreciated.


Post "RE: No option to chose drive letters :- |" has been selected as an answer.
mogs RE: No option to chose drive letters :- |
Expert Contributor 30th Nov, 2010 19:37
Score: 2265
Posts: 6,269
User Since: 22nd Apr 2009
System Score: 100%
Location: UK
Hello.
Can you confirm the version of 2.0 Beta you are using?....If you look in Scan Results/Patched progs.....to the right of the Secunia entry, in the detected version column. Thanks.
Presumably you're already familiar with 2.0 beta to some extent.....Configuration on the Dashboard; then click on Settings. You should then see three tabs....
PSI Settings/Ignore Rules and Drives. Clicking on Drives should reveal those detected, below.
If you click on the Question Mark on the same level/right of the three tabs you will obtain Additional Info.
Hope this helps.......regards,

--
Was this reply relevant?
+1
-0

This thread has been marked as locked.